DOPPLER EFFECT PLUS

So, for example for the default settings (base frequency 1000 Hz, range 10 Hz, step 50 ms), only the autocorrelation around the 49th period (49 times 1/1000 s = 0.049ms) is calculated plus and minus the range of 10 Hz. But instead of calculating the whole autocorrelation all the time, only the autocorrelation corresponding to the frequency range around the base frequency is calculated.Īlso, in order to get a good time resolution, this is not calculated at the first maximum in the autocorrelation function, but at the very last within the frame of the time step. Similar to the simple autocorrelation experiment this experiment uses the autocorrelation to determine the frequency.

However, keep in mind that this also limits the frequency range that you may measure as this should not exceed the inverse of the time step. If your only have slow changes in speed, you should try to increase this value as it acts similar to averaging the data. The time step corresponds to the time resolution at which the Doppler effect is sampled. On the other hand, larger values lead to slower calculations (especially on older phones) and if the range is close to or larger than the inverse of the value in time step, you will get strange results. If this value is smaller than the largest frequency shift in your experiment, the result will be cut off. The frequency range gives a hint to the algorithm which frequencies may be expected. The defaults may be a good starting point, but if you try to measure particularly fast or slow movements, you probably have to optimize these. If you know the speed of sound (this is mostly only temperature dependent), you may enter it as well, although usually the error from the speed of sound is much smaller than other uncertainties.įrequency range and time step are used to optimize the calculations. Therefore, you have to keep in the range of 300Hz to approximately 5000Hz. Keep in mind, that you are limited to the frequencies that can be recorded by the microphone, which is optimized for voice recordings. If you can change the tone of your emitter (like when the emitter is a phone with phyphox), 1000Hz is a good starting point (make sure to set the same frequency on both devices). Set the base frequency in the experiment settings to the frequency of your emitter.

You might be able to improve your experiment by using an external external microphone.

Talking may already disturb the analysis as well as the sound from a loud motor from the setup (for example if you try to measure the speed of a toy train). There should be very little environmental noise during the experiment.

In contrast, some alarm siren circuits or Piezo alerts might not be stable enough as the emitted frequency drifts more than the Doppler effect.

DOPPLER EFFECT GENERATOR

A second smartphone with phyphox and the tone generator experiment or a music player (MP3 player with an audio file of a sine wave) work well. It should be quite stable in the range of 300Hz to 5000Hz. You will need an audio source, which emits a tone with a constant frequency.